Okay, so it looks like I'm going to have to tear my PTO winch apart in order to get it fixed. Two of the mounting brackets on drivers side of the winch broke, so in order to get them welded back in place, I have to tear the winch apart (at least thats what the welder said). I guess since its cast iron, they have to get it super hot to weld back together and thought it best to just bring in the housing, which means tearing the thing down. Does anyone have any detailed drawings/tips/guides for doing this? Doesn't look too complicated, but it would be nice to have drawings so I can get it back together. Are there any seal kits I'll need once I get this thing back together? What type of gear oil is in there now? Sorry for all the questions, but I would like to get this thing working again. The u-joint for the for the PTO drive shaft was busted too, but I have a shop looking at that, they said it was a pretty easy fix as long as they could find the joint to repair it with...however I have a feeling this winchis going to be a pain to get fixed.....