proper fuel sender link

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 14, 2005
Threads
120
Messages
248
I can't find the right one for the life of me. i got the autometer fuel gage 0-90 ohm and need a sender. Can't find it at summit or anywhere. also, has anyone had any success with an in tank pump and sending unit? thanks
 
According to Autometer's site, that ohm range gauge is designed to work with *most* GM vehicle sending units from 1965-1997.


I have not ever modded a Land Cruiser fuel tank to use a GM style in-tank fuel pump and sender combo.....I have had it done to a couple Jeep fuel tanks by local radiator shops....


In-line fuel pumps are too easy, so I would not mess with an in-tank pump again....


As far as your insturment....

I would get an Autometer fuel gauge and sending unit that are made to work together, and be done with it.



If you intend on mouting an Autometer fuel sender to a Toyota Land Cruiser fuel tank, you will need to take the sender apart and re-drill the bolt pattern....no big deal.


Good luck!


-Steve
 
The only fuel tank sending unit that will bolt into a Land Cruiser fuel tank without modification will be an original Toyota sender....or something that someone modified to work in one....


Take the top off the new sender, take the TOYOTA sender gasket and lay it on the top of the new sending unit, mark the five holes, drill them out, put the sender back together, making sure that it goes back together EXACTLY as it came to you, meaning that there are isolating washers that need to go back in the correct loction or your sender will not work properly, bolt it into your tank and call it good.



Really, this is no big deal.


:beer:
 
Back
Top Bottom