Hey Can Anyone Help Me.i Own A 1991 Fj80,and I Have A Rear Axleshaft Oil Leak.i Bought The Seal And Bearings.i Have Removed The Differential Housing And Removed The Pinoin Shaft And Spacer.now The Problem I Have Is Removing The Axleshaft Clip.i Had My Dad Push In The Outer Flanged End ,but I Cant Get Enough Pushed In To Remove The Clip.i Tried Prying It With Other Tools .still No Luck.can Anyone Help Me Or Let Me Know What Im Doing Wrong?thanks My Email Is crazylittlejeremy@yahoo.com
Problem Removing Axleshaft Locking Clip
- Thread starter BENSLC
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
you did remove the big block of steel in the that sits between the side gears right?
the clips keep the axle in from going outboard,
the block in the middel keeps the axles from goign inboard witch keeps the clips from coming out,
the cross bar keeps the block in place and there the a bolt (14MM IIRC) that keeps the cross bar in place
so start with the bolt then the cross bar, then the block then the clips
I think I got that order right.
the clips keep the axle in from going outboard,
the block in the middel keeps the axles from goign inboard witch keeps the clips from coming out,
the cross bar keeps the block in place and there the a bolt (14MM IIRC) that keeps the cross bar in place
so start with the bolt then the cross bar, then the block then the clips
I think I got that order right.