For Sale Prating out 1985 FJ60

[cumminscruiser]

Location

United States

Parting out 1985 FJ60. Whats good:

fuel tank
grey dash board
some interior pieces and trim
door glass and roll-up mechanisms

I have a excelent condition front and rear bumper for a 1987 FJ60 with end caps.

FJ60 trailer hitch.

Non running but complete engine for the 1987 FJ60, I'm not sure why it's not running but I'll look into it today. The carb looks new or atleast very clean.

I'm in the Auburn CA. area.

 

[csd4682]

Parting out 1985 FJ60. Whats good:

fuel tank
grey dash board
some interior pieces and trim
door glass and roll-up mechanisms

I have a excelent condition front and rear bumper for a 1987 FJ60 with end caps.

FJ60 trailer hitch.

Non running but complete engine for the 1987 FJ60, I'm not sure why it's not running but I'll look into it today. The carb looks new or atleast very clean.

I'm in the Auburn CA. area.

Would you sell just the end caps for the rear bumper? Do you have the door mirrors? If so, what do you want for them?

 

[csd4682]

Sorry, forgot to ask this too. Would you sell the suction tube assembly and the sending unit from the gas tank?

 

[LAMBCRUSHER]

???bellhousing, transmission and t case? Could prolly arrange pick up.....???

 

[cumminscruiser]

FJ60

The transfercase and 4 speed are spoken for. although I do have two other 4 speeds.

Bell housing 40.00
Suction tube assembly 10.00
for now I would like to keep the fuel sender w/the tank I can take it apart next weekend.

I'd rather keep the endcaps with the bumpers.

No mirrors.

 

[IH8Wood]

Looking for a good door cylinder, preferably from the passenger side.

 

[FJ40_Nut]

driveshafts, crossmembers, pedal bucket, pedal hardware, clutch master cylinder tubing? If so, I'm interested for my future five speed in an FJ62 and can head your way. Thanks.

 

[cumminscruiser]

Parting out FJ60

Door Cylinder?? is that the lock?? I should have it.

Crossmember I have, Slave tubing yes I think. Pedal bucket and pedal hardware yes.

 

[fj40hokie]

Needing FJ60 Power Steering box????



Any possibility you have the steering gear box and it be power? Please let me know... PM or email to dmacod2@yahoo.com

 

[sfd60]

pic of dash pad please

 

[cumminscruiser]

Parting out FJ60

I would like to keep the engine complete, with carb power steering etc..

The dash is sold but I also have a brown one I'll post a pict as soon as I get home.

 

[RedfishBluegrass]

How's the carpet, and is it available?

 

[cumminscruiser]

Parting out 1987 FJ60

Sorry carpet is gone.

 

[NeoMobi]

Email sent...Thanks

 

[haryv]

what about rear bumper? and inner/outer rear fenders?

 

[cumminscruiser]

Parting out FJ60

I have both inner and outer rear fenders, but it seems a challenge to remove them. Where are you located?

 

[4WD Toyota Owner Magazine]

Need the steering shaft setup to 98531. Thanks!

 

[cumminscruiser]

Parting out FJ60

Is this the part your needing? Including the knuckle and boot assembly. $60.00 plus shipping flat rate I think is $9.00

 

[4WD Toyota Owner Magazine]

thanks for the pic, are the splines trashed? photo makes 'em look a little beat up.

 

[cumminscruiser]

FJ60

The splines are good that's grease.