poor circulation in the block.....

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 26, 2005
Threads
247
Messages
3,274
Location
City that rhymes with fun
i was attempting to drain all the coolant outta my 67 when i pulled one of the block plugs colser to the firewall and there was nothing there?????? the rad is full but there seems to be nothing goin into the block at the back. the truck never overheats or anything which has really got me puzzled....what the hell is the prob???????
 
Could be pluged up with calcium. I had mine dipped in a hot acid bath during the rebuild. Came out spic and span.
 
If you are talking about the block drain on the driver's side, it often fills up with crud. You can gently poke around in there after removing the whole valve assembly and it will break most of the crap loose. Radiator drain is often the same way, but be VERY careful about what you use to poke in there.

GL

Ed
 
All 4 of the F blocks I've messed with were plugged back there. It just seems to be a place for stuff to collect because of the natural currents. In one block, I had to dig it out with a large screwdriver from above (the head off) to clear it. With others, I managed with a bent coat hanger.
 
ah crap im not lookin forward to this at all...........
 
and if this does not work ,what do you suggest, im not in the process of rebuilding?????
 
yah poked around at the temp hole and its not blocked at all, what would be the best way to get her flowing again with the engine still together???? how bout pouring CLR into the rad? or any other suggestions would be of great help. i really dont wanna run it anymore with half the block not getting antifreeze........
 
TSP, or a mix of muriatic acid with water 1:3 dilution, or Prestone's super stuff helps.
 
should i just drain the rad and pour whatever solutin in and leave it sit, cause if it wont open up i dont really want that stuff sittin in the block right???? i can only find one drain on the block.
 
I think you leave it in for 4 hours or so, depending, then flush.

The prestone SUPER stuff comes with instructions.
 
i sure hope that will do it, ill try it out and let yah know how it goes, it will be ok to run the engine with this stuff in wont it, should i drain the rad and stuff first and just run the stp or just pour it in with it still full and let it circulate
 
thats sound good to me dave.............thanks for helpin out a newbie like myself......always appreciated
 
Bretty, do yourself a favor and bypass the heater before you flush the block. The passageways in the heater core are the smallest in the cooling system and will plug up quickly. That = no heat. Just remove the two heater hoses and connect with a piece of copper tubing.
Any of the above chemicals will work, some or all need to be neutralized before refilling.

Please wear goggles when handling this stuff.

GL

Ed
 
connect the 2 removed hoses right? i think that the PO might have flushed it before and not done this cause the heater doesnt really pump out alota heat.....go figure
 
bretty said:
connect the 2 removed hoses right? i think that the PO might have flushed it before and not done this cause the heater doesnt really pump out alota heat.....go figure

Yes, just bypass it by connecting the hoses with a piece of copper tubing. While you are at it, take the heater core out , drain it and fill it up with straight CLR, let it sit overnight and flush. Canucks need heat, don't they, eh?

GL

Ed
 
yah eh!!!!! thats the main reason i dont drive my cruiser in the winter, that and the fact it has no block heater in it.....
 
Back
Top Bottom