Poly axles.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

they are a VERY good product..
 
These have been tested hard in the 4Runner world and are an excellent product. Spendy, too.
 
You do get what you pay for.

IMHO the only better option is Bobby's 30 spoline inners for the front.


there are not better options for the rear..
 
I have a set in hand for my 40 and my 60. They are beautifully made. This is state of the art for a Land Cruiser axle. "These axles have never been broken." That will be a challenge for some!

edit-I should say that I have broken a stock rear axle, and that's with a 2F and low RPM. The repair on the Rubicon was a bitch and that's why I opted for these axles. I told Pig I wasn't going to carry spares this year and his response was "your sh*t won't break, wheel with confidence." Funny.
 
That fronts have been broken...


By the well known leader of this horde..

the rears.. I don't think have failed yet.
 
I have had them in front for a couple years now with Longfields. This is my 1st season with a locked front end though, so time and conditions will tell.

I didn't know PolyPerf was doing rear axels now though. HMMMM....$$$$....Hmmm...
 
By the well known leader of this horde..

the rears.. I don't think have failed yet.[/QUOTE]

I would be concerned that this would move the “weak-link” from the axels to the diff.

Anybody have any problem with this?
 
I got about 18 months of abuse on my Gen2 inners before breaking one....the Longfield was unscathed. Dave promptly sent me a replacement. Apparrently, one other has been broken since then too.

Interestly, the coarse spline front pinion didn't break....I assumed that was the weak point...

I'm now running 30-spline Longfield inners and birfs....with that same POS coarse spline pinion. Have a fine spline set on the shelf, but figger I'll give it a chance first...lol
 
Back
Top Bottom