Please school me!!!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 17, 2005
Threads
46
Messages
186
Location
midwest/G.W.N
I was trying to sneak this question in along with another one i asked yesterday but had no luck getting an answer to i'll give it another shot.
I dont know how to change mt tranny fliud folks, and i dont know what type of oil to use.
i have searched and theres a great deal on the topic but nothing with a step by step on how to DIY tranny fliud change.
If there is and i missed it please pardon me...i'm still quite new to this.
 
Ok I need to confirm, you wrote "mt tranny fluid". Is it a Manual Trans? Or did you mean to say "my tranny fluid"?

If its automatic then are looking for other than opening trans drain plug, draining pan, closing drain plug and filling from trans dipstick tube? I am over simplifying of course but just trying to understand what you are looking for.
 
OK I am gonna jump in here. If I have no idea when the last time my fluid was changed was (if ever), should I take it in and have it flushed or just drain and refill myself like an oil change? I am at 189,xxx now bought it at 180,xxx
 
Get a drain pan , pull the plug @ the bottom of the tranny pan ( its a hex head )
Re-install pan plug w/ new gasket.
Fill per Maint manual with Dextron III / Mercon ATF.
Its a :banana: job just take your time.


You will need a tranny funnel if you do not have one.

hth
ken
 
yes i meant to say "MY" not mt. 450DUDE where does the replacement fluid go in through? under the hood through where the tranny dipstick is?

Yes. A tranny funnel is pretty long and has a narrow diameter end that fits into the dipstick tube.
 
Here are a couple of pics of a flush, but not really step-by-step: https://forum.ih8mud.com/80-series-tech/19299-transmission-fluid-exchange-writeup-2.html


HTH

I used a method like the link above. (start from page 1)Just changing the fluid by draining and refilling you are only changing a small amount of fluid. I ran about 14 Quarts through my tranny before it was clean at about 175K. This smoothed out shifting.

Don't let anyone flush the tranny without knowing what it will do to your truck!
 
So what about taking it to a shop and having them run a flush machine on it. I don't mind spending the $ if it makes a difference.
 
I took my last cruiser in for a tranny flush, as prevent maint. From that day on, reverse never worked rite again. Started slipping in reverse.
 
Only half the job

What I keep thinking everytime I read one of these threads on tranny flushes is "why are you only doing half the job, then complaining your tranny doesn't work?"

After the fluid is flushed (forward flushed, I hope, as reverse flushing causes more harm than good) you then need to go in, drop the oil pan and either thoroughly clean or replace the filter.

When you flush your fluid, all the particulates are still trapped in the filter. And sometimes more get caught in the process. They need to be cleaned out or you're wasting your money on a flush.

Make sure your shop uses a foreward flush machine. Ideally, one that uses the tranny's own pump to move the fluid. We use a BG Products PF-50, although there are others out there of equal or better quality.
 
Back
Top Bottom