PCV #2 hose

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 17, 2003
Threads
9
Messages
189
Location
Charlotte, NC
Went out to replace a bad horn today and noticed a good bit of oil seepage around what I think has been described as PCV hose #2. I searched and that was the best I could get.

I guess I should also replace #1. New valve and grommet? Anything else in this area associated with these symptoms? I'm already placing an order with Dan concerning other maintenance issues and just want to make sure my shopping list is complete. Thanks for the help.
engine1.webp
 
I replaced PCV and grommet, along with both valve cover vent hoses as they were both brittle/cracked.

The PCV grommet removal is a little tricky, you DON'T want to lose any parts down inside the valve cover when you take it out. The grommet is typically brittle also, so removing it w/o dropping parts down the hole is problematic but can be done.

Search and ye shall find a recommended method for grommet removal.
 
yep do both hoses and grommet, see the FAQ about removing the grommet.

looks like you have a distributor o-ring leak, I had the same show up shortly after I adjusted the timing, easy fix, pull the cap off turn the motor to move the rotor to a easily referable position, and remove the bolt pull the distributor replace seal. reinstall with the rotor in the same spot as removed.

Check your air filter and the air intake hose for cracks, , pay particular attention to valleys in the corrugations near the throttle body, especially the underside closest to the valve cover where you could not see with it installed. Wile you are there check the air filter and empty the tuna can under the air filter housing.


when is the last time it had a tune up? if it has been a wile put plugs cap and rotor on the list, check the date on the plug wires, if they are original probably time for new, how do your belts look? If cracked or worn replace,

Pull the cap and filter off the EGR modulator, if you see any carbon at all then orger a replacement,

You may also consider a TB cleaning if it has not yet been done, you will need a TB gasket and a can of 3M throttle plate cleaner, after it is clean check the TPS per the FSM. You will need a set of feeler gauges.

Fuel filter?

Have you done the cooling system yet?

checked valve lash?
 
Both my old PCV and vent hoses were rock hard, the vent hose was split at the clamp by the cover like your's appears to be. The hoses Dan 'just' sent me were nice and flexible.

While I was at it, I ordered the distributor cap seal (packing), oil cap gasket, and a new power steering reservoir cap. None of these appear to be failing...
Just wanna to freshen up a few other things.. :hillbilly:
 
Thanks for the tips. I'll have to stick my head back under the hood and do some investigating. Luckily (maybe not so lucky), the coolant system including radiator, water pump, etc were replaced with the head gasket work. Its about time for a flush though. Plugs, belts and wires were replaced shortly there after.
 
I have the exact problem. PCV 2. I'm a bit scared to do it myself as I'm not to engine savvy. Would a dealership charge me an arm and a leg for something like this?
 
Fj Jason, the PCV hose #2 is very easy, would be a good starter job, I dont think it would take a dealer mech more than 5 min so should not cost much if you want to go that route.
 
Back
Top Bottom