parts geeks

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 24, 2003
Threads
208
Messages
2,210
Ok, what year did the 4 speed case go from coarse spline front output shaft to fine spline front output shaft.

is there an easy way to tell if the early 4 speed single case i have has the lower low range gearing than the newer 4 speed single cases.
 
That would be the difference between a six cylinder gas and diesel trans,(coarse spline input) compared to the fine spline input found with the four cyl diesel engines...iirc.


The four speed transmissions that are available in your neck of the woods *should* be the lower first gear, as the higher first geared four speed transmissions were for the USA.




:beer:
 
sorry i'm talking about the transfer case behind the 4 speed.

the one i just swapped in has a course spline front output shaft. (where the collar slides up when you stick it in 4wd)

i wanted to know which years had the lower low range gearing in the T case
 
The case you installed would be a pre 04/75 iirc.


Pre 1974 Tcases for sure....there are some 1974 cases that had the 2.313 gear set for low range....in the USA ;)
 
this makes things interesting... came out of a 1975, but that thing is a frankensein monster, so thats why i'm trying to ID it.

any easy way to tell... or should i just put it in low range 4th gear, pull the plugs and hand crank it over 10 times and count the turns on the output?
 
Take the side cover off the tcase and measure the thickness of the drive gear on the trans output shaft...


Might even be able to get the Toyota part number off the gear with a mirror and light... :)


That would remove all doubt.


Earlier gears were thinner than the later gears...and lower low range was in earlier cases...'least it was here in the USA ;)


Good luck!


-Steve
 
Back
Top Bottom