Part detail

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 23, 2005
Threads
201
Messages
594
Location
SoCal
Have the factory manuals for body & engine; at least they look official. Is there a source that lists the size of the various bolts, screws, other parts? Is that stuff still available? I'm concerned right now with how to replace the phillips screws I'm destroying in the process of removing back doors, tire carrier, etc., in order to paint the body. As to that, is there some trick to it other than having THE correct size phillips head driver and brute strength?
Vic
Redlands
 
a6016 said:
is there some trick to it other than having THE correct size phillips head driver and brute strength?


Seldom is there an alternate for THE correct tool for a specific job....


There is no replacement for quality tools....the more you pull a wrench, the more this fact will be driven home.


I would get a good quality screwdriver, one with a hex by the handle so that you can put a box wrench on it to assist in turning. Something else that I have found is that when you are using this quality screwdriver, seat it into the fastener BEFORE you try and turn it with a good swing from a hammer...the impact often breaks and bond that the corrosion has on the fastener, and makes it a bit easier to get them out. Put the box wrench on BEFORE you seat the screwdriver into the fastener... ;)


Used this system for many years.....sometime heat is needed to get things to move also.


Good luck!


-Steve
 
I have an impact driver from sears. Combined with the proper size phillips bit, this tool usually does the trick. "each hammer blow develops 200lbs of torque".

I've found that mcmaster carr has a good selection of fasteners, but you'll have to buy them by the box.
impact driver.webp
 
Back
Top Bottom