Painting a disassembled engine

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 22, 2003
Threads
284
Messages
8,118
Location
Kansastitty
How important is it to keep paint off of the gasketed surfaces? Should I mask it off where waterpump, side cover, valve cover, etc?
And does anyone paint their engine anything but black? I really like Plasticote's "Cast Iron" paint. Takes 600* and is resistant to most fluids.

Thanks for helping on this gay question.

Ed
 
I took great care to keep paint off gasket surfaces on my cylinder head. I basically masked off all gasket surfaces, then went around the edges with a brass hammer to cut off the tape. It would have been easier to just paint the entire thing, then wipe off all surfaces with acetone or paint thinner while it's still wet. I used a cheap gloss black rattle can from NAPA and it's held up great.
 
Keep paint off the gasket surfaces.
And I would not paint the engine block black.
Paint it someOTHER color.

Black engine blocks make it VERY hard to spot leaks.
 
Maybe that's why Toyota painted them black to begin with!

OK, I think I'm going with the Cast Finish.

Thanks,
Ed
 
Yoda, I'd assume the manifold gasket area, too?

Thanks,
Ed
 
Back
Top Bottom