P0125B Low ECT for close

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Junk

Mod Emeritus
Joined
Dec 13, 2002
Threads
248
Messages
6,159
Location
buggerville nj
Hmm, truck has been hesitating a lot lately after it gets warmed up. Kind of like bucking when it's got some foot in the pedal - usually at highway speed, but sometimes on backroads too.

Driving home this morning and the CEL comes up. Grab the OBDII as I'm driving and plug it in and get

P0125B Low ECT for close
Loop Fuel Ctrl

Watched the streaming data the rest of the trip (20 mins) and the ECT ranged from 192F to 198F.

Since I'm picking up the squaw from the hospital later today, I won't have time to check this till tomorrow (which is supposed to be a rainy day) so I'll find a self wash car wash and look into it there. I'm thinking it may be the ECT sending unit which from memory is close to the oil filter - just above and slightly behind. I haven't looked at the FSM yet (will tonight).

Anyone have any other thoughts?
 
Just a hunch, Junk. Check the wires to the first O2 sensor; the one before the catalytic converter.

-B-
 
I'll take a B-type hunch anytime. Thanks dude, will look for that tomorrow. Have 2 new 02 sensors been meaning to replace as preventative maintenance - may as well drop them on tomorrow as well.
 
All I got to say is its yours thats why it runs so well :flipoff2:
I know the 62s have a temp sensor just for the ECU nand a 3rd for the cold start injector so even if the idiot dash one is working the other one can go south and make it run rich which will piss off the rest of the system and say "FU" ;p
 
Hey B. Good score dude. Connector apparently was stripped of it's nubs by the exhaust place. It had come apart with part of the connector laying against the cat. Thanks dude. Good hunch indeed.
 
A blind squirrel finds a nut every now and then. :D

And I'll bet the fix wasn't much more trouble than pulling out the MIL bulb in the dash as some others would have you try. ;)

-B-
 
Warning Thread Resurrection!!!

I love search. Thanks B, I had the same problem. My exhaust has a three bolt flange where the at the base of the y-pipe. This gasket blew out, and when I replaced it, the connection came loose to the front O2 sensor. Found this thread, and no more code!:D

Thanks to the advanced search, I haven't started 1,000,000 new threads on topics that have already been covered and discussed!!!
:cheers:
 
Back
Top Bottom