Overheating

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 23, 2009
Threads
4
Messages
12
Location
Sherwood, Oregon
I am at a loss....I have a 91 FJ80 and it keeps intermittently overheating. I am scared that it is the water pump ($$$). a few weeks ago it overheated and I pulled over immediately. A friend came over and helped me and we changed out the thermostat. On my way home it overheated again (not all the air was out). We got the air out and all was good for a week then the intermittent overheating began...just did a radiator flush a few nights ago and has over heated twice. The head gasket is ok (had it tested). The radiator is next to be replaced (it sat for two years a few years before I bought it). I am taking it in next week to have the water pump checked. I have heard that they are tough to replace and mechanic wants almost $600 and the part I can get for $300. Any other things I should check? :bang:
cruiser.webp
 
Is it overheating on the freeway, or at slower speeds.

If it's on the freeway, it's most likely a radiator issue. If at slower speeds, more likely a fan clutch that's not engaging properly.

First of all, make sure the OUTSIDE of the radiator and the A/C condenser core are clean and that air can easily pass through. Hose them down, and/or blow compressed air through them.

You can take the radiator to a radiator specialist, they can remove the top tank and rod-out the radiator and put on a new top tank, this will get the radiator flowing and will cool as good as a new one at a fraction of the cost.

IF the water pump is bad, that would be the time to replace it, while the rad is out, much easier to get at. I haven't done a water pump on a 3FE, but $600 sounds a bit high! Call some other mechanics for bids.

Another possibility: If the lower hose is really old, it can get soft and will sometimes actually collapse at higher speeds. The lower hose is the suction side, the water pump sucks water from the bottom of the radiator. If the hose is weak, it can actually suck closed and block water flow. check the condition of the lower hose.
 
Last edited:
It is only when doing freeway driving. It takes about 20 minutes and then its slowly gets warmer and warmer. It cools at idle. I will pull over and let it sit for 10 minutes and it is back to normal. I will start researching radiator specialists tomorrow unless anyone knows of a good one in Tigard/Tualatin/Beaverton/Sherwood, Oregon area. Money has been a little tight so a friend of mine has been helping me work on it as long as I know what is wrong.

I am so ready to start doing the fun stuff to my new Toy but have to get the engine stuff done first :(
 
It is only when doing freeway driving. It takes about 20 minutes and then its slowly gets warmer and warmer. It cools at idle. I will pull over and let it sit for 10 minutes and it is back to normal. I will start researching radiator specialists tomorrow unless anyone knows of a good one in Tigard/Tualatin/Beaverton/Sherwood, Oregon area. Money has been a little tight so a friend of mine has been helping me work on it as long as I know what is wrong.

I am so ready to start doing the fun stuff to my new Toy but have to get the engine stuff done first :(

Ok, I think you can safely eliminate the fan clutch from the equation.

Check the other items I mentioned, then report. This is a classic symptom of a plugged radiator, but the other items can mimic it.

BTW, I haven't heard of a water pump failing on these engines in such a way that they stop pumping water. I've only heard of them failing by leaking. So if you have to pull the radiator, that is an excellent time to do a close phyiscal inspection of the water pump, looking for evidence of leaking.
 
You can get it rodded out, but you'll need new tanks installed. No guarantee that it'll be done completely right, so make sure you take it to a reputable shop if you go that route.

Otherwise, you can go with an OEM via cdan.
 
How would you unplug it....LOL. I will have to wait till I can get a friend to check those things because I am not good with cars but sure am learning alot with all the work I have had to have done.

A GOOD radiator shop will be able to put small rods through each of the little holes inside the radiator where the water flows, this cleans them out so the water can flow through them again, cooling it.

Ebag333 is right, you will need a good quality radiator shop to do this. BTW, bottom tanks rarely fail, my guy who did this said he's only seen 2 bottom tanks need to be replaced in 25 years in the biz. The top tanks fail quite reguarly, so I'd get that done at the same time.

It's a very cost effective way to get a cooling system rejuvenated.
 
A cheap way to check if it is plugged is when it is warmed up feel the radiator and see if it has any cool spots if so it is plugged. Sounds like that's what it is though. I would change the oil in the fan clutch too. Search around for that. Should cost about $5 for the oil at most Hobby shops.
 
The '80's are fan dependent at highway speeds, so if overheating my first check is always the fan clutch. When the motor is hot, does the clutch have good drag or spin relatively freely? If it's the original clutch clutch, the fluid is probably done, changing the fluid is inexpensive, easy and very effective.
 
The '80's are fan dependent at highway speeds

Not entirely true.

My 80 ran just fine on the freeway with a fan clutch that was spinning, but wouldn't lock up. It was driving around town that would see temps start to climb. This was in one of the hottest points in the year (with 90+ degree weather).

If your cooling system is in good shape the temp should not climb when driving at highway speeds. Be somewhat higher than normal, yes. Go into the red? No.


That being said....it's simply good advice to change the fan clutch and/or fluid.
 
The spring in your bottom radiator hose is broken. This allows the hose to suck shut going down the road. See if you can squeeze the hose shut.
 
Last edited:
Back
Top Bottom