orion in.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 20, 2004
Threads
129
Messages
6,697
Location
here
done. it's in . feels a little tight but thats good , right ? no comments texicans...
new 420 and the orion , with new discs on the front , iy is gonna be a good winter. Yeah , we can wheel out here in the winter. Oh , and the low range with the tranny in granny is
nnnnnnnnnnnnnniiiiiiiiiiiiiiiiiiiiiiiiiccccccccccccccccccccceeeeeeeeeeeeeee!!!!!!!!!!!!!!!!!!!!!!!!
:bounce: :bounce: :bounce: :bounce: :bounce: :bounce: :bounce: :bounce:
 
Congrats.

I have installed one in a '74-40 with a non-USA tranny, 81:1 is pretty sweet, she is very happy.

Working on the same for a'78-40 with a V8, he drove her truck twenty feet, and was sold on it.

Have had a pile of fun getting the Orion to mate up on the rear of the 465 toybox, but it is in, and hopefully will be back under its own power here in the next week.


:beer:


-Steve
 
congrats, you will love low gearing. i whish they would put out the cast iron replacement case though, i run a 4.7 marlin and the orion on top would just be stupid slow but if i could just get that cast iron case.
 
well , the sob pops outa gear , only high range. Tightened screw on shift fork and still pops but only when really gettin on it in third.
Does this mean I didn't get the thrust right and the gears are walkin back and forth , we can't figure what would cause it to pop out.
Also , leaks at speedo cabl and idler shaft , bastard. It's just as noisey as the stocker.
What with the two quarts of fluid it comes with , did not seem to fill it all the way and I don't want to mix 90 in it ?
It is so smooth though , I like it. Feels tight , like it needs break in too.
 
Are you positive that your linkage is not somehow the cause of this popping out of gear?

Not specifically with the Orion, but with the Land Cruiser, this has been an issue with many people.


There really is not any room for the gears to walk back and forth, so to speak...and if the pre-load was so far off that it permitted the gear/shaft assembly to move, you would have other issues, like the rear output shaft seal leaking like mad, etc.


Idler shaft o-ring was damaged during assembly, that is why it is leaking..


Torco oil is supposed to make things run quieter according to AA. I run 80W90 without any issues so far...


Good luck!


-Steve
 
If it leaks at the idle shaft, I would check out the O-rings to see if they were damaged during installation. What's the condition of your hi/low shifting collar? Did you measure the tolerance between the shifting fork sitting inside the collar just like in the FSM?

A newly rebuilt transfercase shouldn't have these problems, I would fix them before putting more miles on it, you may put more damages on it.

/td
 
Back
Top Bottom