Oops - I broke it....

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 2, 2004
Threads
153
Messages
5,861
Location
Hamburg, AR
Need a little help guys. I was wresteling the clamps of the PHH when apparently my wrench slipped. I didn't feel it but noticed a short time later that I had busted the electrical connection to the sending unit about 2" directly below the PHH. I don't yet have a service manual so can someone tell me what this sending unit is - maybe a part number? Thanks in advance.:frown:
 
Knock sensor?
 
Knock sensor it is - thanks guys! It may have been broken before I started as the plastic connector just crumbles in my hand. I'm going to try my hand at a field repair but not much of the original wire is sticking out from the sensor - nothing to lose trying. Thanks again!

Finished the same repair outlined in the post above and all seems well. I'll post again if it throws any codes. Thanks again for the help!
 
Last edited:
Back
Top Bottom