? on Starter bottom bolt

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

bluto

More questions than answers.
Joined
Apr 29, 2005
Threads
55
Messages
1,174
Location
North of LA County
Ive reference Georges website on Starter Contacts rebuild.
Trying to remove starter bolts 17mm starting from the bottom.
Which bottom bolt close to bell housing to take out?
Big red arrow point up.
666666666666666666666666666666666666666.webp

starter pic.webp
666666666666666666666666666666666666666.webp
starter pic.webp
 
Remove top most bolt. #1 in your picture.
:flipoff2:
 
Last edited:
Number 1 from picture then. Thanks

Another question - how in the heck did you guys remove the top bolt 17mm on top of the starter.

Just using muscle here and no room for leverage and Im using a uni joint with extension and I tried the plain 17mm wrench. I dont have impact wrench.
 
I used a flex head rachet in combination with an extension and uni.
 
Ron, Ive been using an extension and a uni. I can get on the bolt but the bolt wont budge.

Im also weary of rounding out the bolt head - I dont want to be f..k with that. :D

Any other suggestions?
 
I used a flex head rachet in combination with an extension and uni.

Ahh. Saw that today at the store but I thought I wasnt going to need it.
Back to the garage then and see what I can do with what I have.

Thanks in advance if you guys posts anymore suggestions cuz it might be a long night.

I might have to put the plugs back and the 12mm nut so I can drive my kid tomorrow morning.

Thanks again.
 
The flex head rachet should allow you to position it for maximum leverage. You're only going to have enough space to rachet a couple clicks at a time. Be patient and find the right angle to get enough room to torque it loose.
 
I managed to use the handle from my jack as a cheater bar and it worked perfectly. Like roncruiser stated, you will only get a couple clicks at a time, but you will get it. It only took 10 minutes to replace the plunger and contacts, but probably 40 minutes or so to get the starter removed and the same to get it back in.

I think when I did it, I took out both of the bolts you referenced in the original post by accident, and remember being pissed that I did all that extra work! Good luck!
 
Breaker bar with a 17mm socket and extension. The breaker bar provides leverage because of it's extra length. PB blaster helps.
 
Back
Top Bottom