? on cutting rear Q'trs

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

I used the $OR fender flares for the rear. The top cut out is hangs down approx. 1" from the wheel well. The flares provided a pattern for me to cut out the rear 1/4's wide enough for 35's to fit in w/o rubbing. However, because of my suspension & body lift, I could easily stuff 39.5's in w/o rubbing.
 
I did not snap "before pics" however I just finished replacing my rear quarters. What are you exactly looking to do? Replce the section''s above the bumperett's? My cancer went around the bend in the fender and right to the rear wheel, so I made a template out of the older quarter with cardboard and fashioned a new quarter from 18ga steel. I cut the steel, then rolled it match the contour of the original piece than I migged it in.

Other catch is that the cancer was not as much in the sheet metal as it was in the support behing the quarter panel, I had to build one of those as well.
 
Check the link in my sig line for my rear fender cut out.

Lay out your pattern on the car, leave a 1/2" lip to fold inward for strength.
I used a hammer and dolly and a pair of wide jaw vise grips (to start the bend).

Good luck
Tony
 
Back
Top Bottom