Oil Pressure Observations

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 12, 2006
Threads
124
Messages
1,109
Location
St. Louis, MO
I know this has been discussed alot, and may be of interest only to Romer and Cary at this point, but here it is anyway.

After far too much reading on this forum and personal debate, I changed the oil and filter yesterday (OK, someone else changed it for me, but that is a whole different thread :rolleyes:).

Previously, my Toyota dealer had the newer small filter (yzzd3 I think) installed and Castrol GTX full synthetic 5w-30 Oil. I switched to the recommended filter (20004) and Mobil 1 Diesel Truck 5w-40 full synthetic. Put in the full 8 qts.

Previously, there was very little movement in my oil pressure guage once the engine was warm. Whether accelerating or at idle, it was pretty much in the middle.

Now, I noticed today that at idle it is just at or below the lower 1/3 mark on the guage and when accelerating, it is at or just above the upper 2/3 mark on the guage. ON EDIT: it moves really, really fast too.

Again, from everything I read, this is not abnormal. I'm just curious what causes the difference - and I was hoping for more detailed explaination than 'the weight and viscosity causes this' but I'll take what I can get.

Thanks!
 
I noticed the same thing with the Lexus V-8 filter and systhetic 5w40. In fact it was so pronounced that I went out to wally world bought 2 gallons of Rotella T, went back to the lube shop and had them dump the synthetic and put the rotella in. Same Lexus V-8 big filter. Much better now. Still not where it was with the Toy JDM small filter so I am wondering if the bigger filters cause a drop in pressure. I am planning to install an Oil temp, and pressure gauge so when I do, I am going to revisit this issue. Al a minimum I will go back to the JDM filter chart some numbers, then switch to Lexus V-8 filter and chart some numbers. Then I will try the synthetic again.. Scared the hell outta me when I saw my oil pressure gauge about 1/3 of the way between the first line and the second line. or in other words 1/3 of 1/3...
 
I noticed the same thing with the Lexus V-8 filter and systhetic 5w40. In fact it was so pronounced that I went out to wally world bought 2 gallons of Rotella T, went back to the lube shop and had them dump the synthetic and put the rotella in. Same Lexus V-8 big filter. Much better now. Still not where it was with the Toy JDM small filter so I am wondering if the bigger filters cause a drop in pressure. I am planning to install an Oil temp, and pressure gauge so when I do, I am going to revisit this issue. Al a minimum I will go back to the JDM filter chart some numbers, then switch to Lexus V-8 filter and chart some numbers. Then I will try the synthetic again.. Scared the hell outta me when I saw my oil pressure gauge about 1/3 of the way between the first line and the second line. or in other words 1/3 of 1/3...

I recall almost 20 years ago sitting in a Corvette at the Bowling Green Plant that makes them, I was at raceway where they test Corvettes(I knew the plant doctor, and he got me a ride on the track);
I remember watching the digital oil pressure guage when at idle
and it was at 5, then the driver stepped on it which threw me back
in the seat like the take off of an F-16(been in those also, really);
the pressure shot to the top.
They were using Mobil 1 then, and ever since, as a factory fill.

I would not dump out any synthetic oil due to oil pressure concerns; it works better and lubricates better than any conventional oil can.

For the other poster who saw more fluctuations; this says to me
that the new filter allowed more flow, not less, as the pressure
shot up;
I see this all the time; my needle is usually at 9 o'clock ( in the middle) at idle with 10W-30 Mobil 1; then on hard acceleration or at high highway speed (80mph) it is about two needle widths above the top line.

Toyota Filter(the big black one) and Mobil 1.

g
 
Back
Top Bottom