Oil pan rust through

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 4, 2004
Threads
215
Messages
2,110
I have a small rust spot on the bottom of an oil pan, is the pan stainless? What would you use to weld seal or other methods to seal the leak? What have others used to seal these up in a permenant way, thanks, Larry
 
If it was mine I'd braze it.

I'd want to remove the pan to see the extent of corrosion because there can be quite a bit before it gets to the point of making a visible from underneath pinhole leak.
 
Thanks Honk, I removed the pan, the spot on the inside is the size of a pencil eraser but it's covered on the outside by the skid plate so I am a little concerned that the rust area is much larger, however when the oil began leaking if may have inhibited any new rust, Thanks, Larry
 
brew8 said:
Thanks Honk, I removed the pan, the spot on the inside is the size of a pencil eraser but it's covered on the outside by the skid plate so I am a little concerned that the rust area is much larger, however when the oil began leaking if may have inhibited any new rust, Thanks, Larry

Fairly common failure mode - the skid plate gives a place for road salts and rust to accumulate. Rust, being self catalyzing, will spread in there like a hidden fungus.

Only long term solution is to pop the skid plate, braze the pan, and put the skid plate back on in a fashion that doesn't harbor rust (I'll leave it as an exercise to come up with that method.

IMHO, just get a better pan/new pan, have it dipped to get rid of the rust, and seal the skidplate joint.

Kirk
 
You can drill all the spot welds out, remove the skid plate, evaluate the extent of the corrosion, remove the corrosion, repair the pan and install the plate again....

----OR----


Just drop the money on a new pan that will last you the remainder of your time with the Land Cruiser.






I have repaired oil pans in the past....knowing what I know now, I just install a new pan and do not look back. It is not worth my time to mess with them.


Good luck!


-Steve
 
i heat the plate and pund it down to the pan them mig weld it solid all the way around 1 on my tuck was done in 77 and hasnt leaked yet and im in salt central here to top it off they now ad brine
 
There is a very cheap metal treatment that can be found in most cities, its called Aerodite treating (its also known as a another name but I dont recall it at the moment).. once treated it will never rust.. and the treating is really cheap.. most chrome shops, if they dont do it, can tell you who does.

Its that metal treatment you see on some parts that are aftermarket parts, they are a gold iridescent colors.. if I could find a place with a big enough tank I would have my whole FJ dipped! but, I would just end up bored, with all the oil leaks and rust spots fixed.. I wouldnt have anything to do but drive it! BORING!
 
Back
Top Bottom