OEM pressure hose?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 9, 2005
Threads
271
Messages
5,828
Location
Cary, NC
I know I saw a thread where someone used an oem hose for a saginaw conversion, but now I can't find it. I broke down and got a new pump to avoid a flared / o-ring mix match. I'm now running a '68 Skylark gear and a '68 Impala pump.

If I can get by with a $15 or so replacement part hose from the local parts house instead of having customs made, that's what I would love to do. Napa store told me they could make them, but they are looking and just using flex hose with the appropriate fitting to match the box/pump. Sounds like a leak waiting to happen if you ask me.

Sorry, I tried to search for sometime and I just couldn't find it. Seems like it was a Heep part????
 
I had mine custom made at CarQuest for less than $20. Same fitting for both pump and mini box, in my case. Maybe different for your skylark box? I would not be afraid of a hose as opposed to a hard line.

ED
 
mtweller said:
If I can get by with a $15 or so replacement part hose from the local parts house instead of having customs made, that's what I would love to do. Napa store told me they could make them, but they are looking and just using flex hose with the appropriate fitting to match the box/pump. Sounds like a leak waiting to happen if you ask me.




This would only be a leak waiting to happen if they did not crimp the fittings to the hose properly or used non-compatible hose with the fittings. The thing that you are likely going to have a hard time finding at a NAPA or other automotive store that can make hydraulic hoses would be the 90-degree –7, 45-degree flare fitting to crimp on the end of the hose that attaches to the steering gear. The pump side is –6 and pretty common.

I run fabricated pressure hoses on all the conversions that I do. Some have been made at CarQuest and NAPA over the years others have been made by Caterpillar. I would take a properly fabricated pressure hose over a off the shelf piece that may need to be modified/bent to work any day.


You will likely end up needing to have two 90-degree fittings crimped on the hose. I have them crimp one fitting on the hose and leave me 36” of hose that I can install into the other fitting and mark both the hose and the fitting with a paint pen where I want the fitting to be orientated so as to remove any twist that may end up being present when the hose is installed. This is what I have done for Saginaw power steering pumps that were installed on the driver side of the stock six cylinder engine.



Good luck!


-Steve
 
Back
Top Bottom