Odd rev upon start-up

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 22, 2007
Threads
10
Messages
34
Location
Denver Colorado
hey all,
I have a '97 Lexus LX450
had a wierd thing happen today, I stopped to get gas (not so wierd haha) and decided to pop the hood and look around a bit. I checked the oil and added a half-quart. Then I decided I would unplug the battery terminal for 10 sec. to turn off my check engine light. (codes thrown are O2 sensors and EGR valve) I just wanted the check engine light off for a little while and to see how long it takes for it to come back on... usually a couple hundred miles. Anyways, when I shut the hood and started the sexy lexi back up, the revs jumped up immediatley to 2000 to 2500 rpm, then jumped down to idle, then suddenly shot back up and fluctualed for a few seconds 'till I shut it down! This was kinda scary and I would really hope this doesn't happen again at an "innoportune time." The cruise control was off and my foot wasn't on the skinny pedal! Any thoughts on what it was? The computer re-setting itself for fuel needs? When i started it back up again, everything was fine and I went about my day, not noticing anything out of the ordinary, and enjoying a dash with no lights!

Thank fellas!
 
The engine rev up after disconnecting and reconnecting the battery is normal. I almost went through my garage wall when I learned of this phenom.

I think that it takes a minimum of 5 starts or so then the computer will calm down.
 
Usually just does this the first time you start it up after disconnecting the battery; normal relearning
for the ECM(computer brain). Lots of threads on the EGR P401 code; check all the vacuum hoses carefully (make sure they are connected, tight, and not cracked) and clean the heck out of all the ports, throttle body, etc,etc. Do not spray cleaner into the little port/nipple on the rear of the intake manifold; the one that connects to the EGR with a short 7 inch section of hose; this little port goes directly into the VSV, not just into the manifold. Read the threads; wish I had before I started.

g
 
Back
Top Bottom