O-Ring on the distributor shaft

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 5, 2006
Threads
107
Messages
526
Location
USA
I replaced the O-Ring on the distributor shaft, then put the dizzy back in the way it came out (I least I thought so) and have gotten terrible gas mileage ever since. What gives?

Which way do I move the dizzy to advance the timing?

I was averaging 15 mpg before and now only 10 mpg.....:mad:

Still looking for the person (in SLC, UT) to help me with the CDL and PHH....willing to buy them lunch or something more.
 
Last edited:
Nobody knows how to advance the timing on a fzj80?

I have removed the bolt on the dizzy shaft and rotated it down...when I did this the idle went up to 900rpm..and when I backed it off (meaning rotated it up) the idle went to 500rpm. So whcih way is advancing the spark and which is retarding it?
 
Last edited:
Just do it with the engine running and you can hear the motor react to it...small, slight movements.

BTW did you put the sprocket back in correctly, aligned?
 
I have removed the bolt on the dizzy shaft and rotated it down...when I did this the idle went up to 900rpm..and when I backed it off (meaning rotated it up) the idle went to 500rpm. So whcih way is advancing the spark and which is retarding it?
 
IIRC turn the distributor clockwise will retard the timing. You still need a timing gun to set the timing correctly.

I turned it clockwise and the idle increased- and it ran better, more power. When i turned it counter-clockwise it idled down (almost stall) and ran poorly. So are you saying that retarding the spark made it run better?
 
If you were off to begin with, then you may have been to far advanced and are just putting it back where it needs to be.
 
Back
Top Bottom