Noobie Question Re: Warn 5687

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 15, 2005
Threads
225
Messages
2,422
Location
Alexandria, VA
What is this thing???

My recently purchased FJ40 came with an old Warn 5687 winch - no control cables, but it does have the switch under the hood. Before I run power to the motor to see if it works, I want to know what this piece is.

On the same battery terminal (I have 2 batteries running in series) that has the wire to the switch, there is an extra wire running to this mystery jack. And a ground wire running from this piece to the frame.

I could find anything like this in the wiring diagrams in the Tech Links section or in any other post I could find.

I don't really know much about this stuff, so sorry if the answer is painfully obvious.
 
I have a 5687 also. I've never seen anything like this. What year is your cruiser?




Felix said:
What is this thing???

My recently purchased FJ40 came with an old Warn 5687 winch - no control cables, but it does have the switch under the hood. Before I run power to the motor to see if it works, I want to know what this piece is.

On the same battery terminal (I have 2 batteries running in series) that has the wire to the switch, there is an extra wire running to this mystery jack. And a ground wire running from this piece to the frame.

I could find anything like this in the wiring diagrams in the Tech Links section or in any other post I could find.

I don't really know much about this stuff, so sorry if the answer is painfully obvious.
 
The cruiser is a '75.

So, this thing probably has nothing to do with the operation of the winch?
 
That is just a quick disconnect for another accessory or plug in jumper cables like a tow truck would use. Nothing to do with the winch.

I think you meant your batteries were in parallel not series. Series is negative to positive of the second battery and the second battery negative to ground. That would get you a 24 volt system. Parallel would be positive to positive and negative to negative both grounded, retaining 12 volts.

Parallel is a great short term power reserve, but long term the batteries should be isolated, because if one poops out the other will also (technical description).
 
Yep, parallel. Thanks. I just ran down to the parking garage to make sure.

So, now that I have that straightened out (thanks to your help), what's the best way to test the motor on the winch? Running power straight from the positive terminal to the terminal on the winch motor? If so, do I need to disconnect the knive switch under the hood beforehand?
 
if the knife switch is hooked to the batery and the winch, put the winch in free spool (side lever) and close the switch for a second. I replaced my knife switch with a Ford heavy duty starter solinoid and just have an in-cab toggle to operate. much earier than the throttle cable operation.
 
Back
Top Bottom