i’m pressure testing my radiator and the fittings from this kit just /barely/ won’t fit over that little horizontal “lip” at the radiator.
i don’t want to try to muscle it. so i was going to take a construction razor blade or even some sand paper and work the vertical surface at the lip down a little. i would tape off the hole at the radiator with some duct tape before doing this.
wanted to be safe rather than sorry so i hope the mud godz don’t mind the question.
also, i like to think noob posts help other noobs and then they help other noobs and so on and eventually everyone is at least a half decent wrench. or at least they aren’t making dumb mistakes breaking s***!
i don’t want to try to muscle it. so i was going to take a construction razor blade or even some sand paper and work the vertical surface at the lip down a little. i would tape off the hole at the radiator with some duct tape before doing this.
wanted to be safe rather than sorry so i hope the mud godz don’t mind the question.
also, i like to think noob posts help other noobs and then they help other noobs and so on and eventually everyone is at least a half decent wrench. or at least they aren’t making dumb mistakes breaking s***!