No electricity? please help

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 18, 2005
Threads
14
Messages
58
Location
Orlando, Fl
So here's the story...
My 72 Cruiser needed a carb adjust so i took to the mechanic. Battery was dead when i took it there.. Moral of the mechanics story was need to carb.
So I bought a rebuit stock carb from SOR and me and sandrider put it in today along with a new fuel filter. So when we went to start the truck to try out the carb and adjust it, it didn't do anything. I'm talking absolutly no power was coming into the truck. Well duh, the batterys dead. So we tried jumping it, that didn't work...still nothing. We took the terminals off and literally connected them to the jumpers with out having my battery intact, still nothing. Some people said its probably just that my battery is so dead...currently I have it charging. Tomorrow i'm going to try it again. But any advice until then. If that wasn't the problem what could be? I'm clueless if a charged battery still wont give the truck any electricty. Oh we checked the terminals too and cleaned them and they were hooked up good and everything no corrosion. Advice anyone? thanx

Ryan
 
Last edited:
Try Sandriders battery.
Fusible link?
Any fuses in line?
Do the headlights come on? Even dim?
 
I cleaned both the terminals and tried another battery, still nothing. I checked all the terminals and cleaned them and it still seems to do nothing. The lights wont even come on. Do you think it could be the regulator?
 
Not the regulartor, you dont have a ground.

Simple test. if you have a tester light. Stick one end on neg. the other on Pos. the small light bulb should come on. no matter how dead the battery is.

Putting a good battery (sandriders) in your truck is taking the battery out of the equation. leaving your wiring. its gotta be a ground. or maybe the fusable link.

Do you have the battery, AND the engine grounded?
 
not the reg, it would still start.

gounds, fusilbe links, look over anyplace you worked near for something knocked off.

its not the starter if you don't have any power.

Newrider said:
I cleaned both the terminals and tried another battery, still nothing. I checked all the terminals and cleaned them and it still seems to do nothing. The lights wont even come on. Do you think it could be the regulator?
 
Where would a fusible link be...i don't know what that is. but maybe that is what the problem is cause i prolly haven't checked that out.
 
Fuseable link is a wire coming off POS cable with an inline fuse holder. This fuse pops , cutting power to components before overloading them and causing further damage. Usually pretty close to the battery terminals.
 
gotcha...I FIGURED IT OUT!!! i found another ground...apparently someone decided to put 2 grounds on there and the second one is on the front bummper..yea outside, means rust..could barely even see the terminal seated there...cleaned that up...and got the power kickin...i'm posting a new thread on adjusting my carb. Thankyou for all your help i really do appreciate it.
RYAN
 
Back
Top Bottom