new gears

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 28, 2005
Threads
71
Messages
437
Location
spicewood,tx.
i will probably get flamed for this as everyone but me knows the answer. i know look in all the pbvious places, but right now i cant remember where (check the time). i have a 75/40 that is a possible dd. right now it is about 3 grand at 60 mph. i thought maybe a 3.73? gear will do better. my question is i obtain slugs from a later model 40 (like a 79) will they bolt in or do i have to change the axles? you know (i dont) coarse versus fine splines. thx :beer: :beer: :) jim
 
IIRC the axles will work, your 75s are fine spline too. There may be a difference on the pinion side (I cant remember what it but it is nothing difficult). The later gears (40 or 60) will be 3.70s not 3.73s.
 
Hi All:

You might have an issue with the drive shaft flange bolt patterns if you simply swap third members. A '75 FJ40 has "coarse" spline pinions, while the '79 FJ40 has "fine" spline pinions. To make the swap work you'd just need the pinion end of a drive shaft from a '78 and up 40 Series to mate with your '75 drive shaft (all drive shafts are "coarse spline" on the slip yokes! ) :grinpimp:

Regards,

Alan
 
Back
Top Bottom