Wanted Needed: Knucles To Hub 76&up

[cruiserdemon]

Location

United States

Looking for a complete set up from the knuckles, (to include steering arms) to the hubs for a 76 and newer cruiser. Would consider whole axle purchase if not to expensive. Will travel to dissasemble/pick up around KY,TN area Dave 520 661 3087

 

[66fj40x2]

Look for a '79 -'85 solid axle 4x4 Toyota Mini-Truck. You'll get large birfs, large bolt pattern knuckles and disc brakes..... and, at least around KS, you can get the rust buckets for a couple hundred bucks and have parts to sell off to get that money back, making the disc brake swap FREE

Or at least for Mini-truck stuff too.

Good Luck!

 

[cruiserdemon]

Cool, thx for the heads up, I hear about this all the time, the only question I have about this is, will my stock master cylinder put out enough fluid for the mini truck calipers? I have the twin reservoir and vacuum booster. --Dave

 

[66fj40x2]

It's worked fine for me with four wheel disks and 37" MT/R's. If you run into an issues you can easily swap in a later master too.

 

[cruiserdemon]

Just picked up a mini. What did you have to do to adapt the brake lines?