Need Weber 38 help...

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 19, 2004
Threads
213
Messages
4,421
Location
Hotel M-F, home weekends!
Trying to figure out how this thing mounts....Purchased this thing used & it came with carb, some bracket & filter. On the left side is the what I think is mounting base, middle is the orig. one that came off & right being carb. I have tried mount the base that came with carb on studs-no luck, tried mounting carb in intake studs no luck. Thanks in advance.
 
The alum one of the left, can't tell by the pic for sure, but I think it is 2 sections, it should seperate, one bolts to the intake with allen heads, of course you remove the factory studs.....then the Weber adapter bolts to it again with allen heads, there should be 4 studs then that install into this section which the Weber goes on., and they are a bitch to get to .........
 
Be careful with the aluminum plates. Every single kit I have ever seen, the bolts are too long. As you tighten the two plates together the screw will bottom out. At first everything seems fine, but over time you will develop a vacuum leak. You can almost tell who is running a Weber by the high pitch whistle the leak makes. Grind off the last two threads of the 4 bolts and everything bolts together correctly.
 
treerootCO said:
You can almost tell who is running a Weber by the high pitch whistle the leak makes. Grind off the last two threads of the 4 bolts and everything bolts together correctly.

I remember those days. That was annoying as hell :rolleyes:
 
Texican said:
The alum one of the left, can't tell by the pic for sure, but I think it is 2 sections, it should seperate, one bolts to the intake with allen heads, of course you remove the factory studs.....then the Weber adapter bolts to it again with allen heads, there should be 4 studs then that install into this section which the Weber goes on., and they are a bitch to get to .........

that's it, they were screwed together to make sure the bolts didn't get lost and that you knew which ones went where. That one never had a problem sealing or with the bolts being to long that I remember.
 
Thanks you all...install occuring later this week....I have to attend to business Wed & Thur.

Thanks again!
 
Check out that paint job. I got's to get me one of those! Just kiddin' Brian. You need to come look at my set-up. Mine is the same.

later,
 
Best advice I can give you is to sell it and rebuild an OEM AISIN carb with the proceeds.

I had a worn out AISIN on, put a new Weber on -- hated it, sold it and rebuilt my AISIN with the proceeds.

In the top 10 best things I've done to my 'Cruiser

Jody.
 
Mine has been on since 1991...

The only thing that 'might' make me remove it would be FI...


Have installed many others, that all seem to work just fine...


Good luck!


-Steve
 
A well tuned Weber is great, but I may give another asian a try since I have a newer one lying around to see if it actually works better off camber. My F runs really strong and gets good gas mileage with the Webber once I got the jets worked out.
 
Back
Top Bottom