Need Spindle Bolt Torque Settings

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 20, 2005
Threads
198
Messages
2,611
I'm on the fourth rebuild of my front axle in about the last 7 years (not including field fixes for busted birfs) due to upgrades every few years, and I never understand the Chilton's 14.5 ft/lb setting for the spindle bolts? So I end up searching for the correct settings each time - and never seem to remember - I mean this is soooo low I'm converting to 162 inch/lbs - on my small torque wrench. What gives - is 14.5 correct?
 
Spindle bolt?


Are you talking about the BOLT used to hold the spindle to the knuckle?



Or are you calling a spindle NUT, the one that retains the wheel bearings a BOLT?
 
Poser - Thanks those were the numbers I used in the past. From reading the other thread I"m guessing my generic Chiltons just lists the 8mm torque settings.
 
Back
Top Bottom