Need some seat frame ideas.........

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

If the stock tank is gone, why not go with frames from a bucket seat truck, post 72?
 
You could use something similar to the frame from the original which went over the gas tank (creating some cargo space), that's what I did (accept my stock gas tank still remains)...

Kept the small compartment under the drivers side, used part of original hardware to mount new bucket seat which could be lifted to gain access to tool box.
 
thanks, I am making something custom and was looking for ideas. I am going to completely enclose the space under the seat and use it as a place I can secure odds and ends(to include spreakers and an amp) and was wondering if anyone else had done the same or attempted it.
 
Mine's a 2 piece design, which is removable. The angled bars at the doors connect to the rear rollbar & also join together in the middle, down by the where the rear heater used to mount. I used a seperate & larger O.D. tubular bracket there. As you can see the stock tank is there but I had to go to a smaller dia. steering wheel due to the raised ht. of the seats.
DSC00106.webp
DSC00190.webp
DSC00110.webp
 
cool, i'm in the process of using a mini truck tilt column............ either that or I will bite the bullet and get a flaming river that will allow me to remove the steering wheel and take it with me.
 
Back
Top Bottom