Need pre-welding measurement

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 15, 2005
Threads
13
Messages
42
I am ready to weld my CCOT wheel wells and need the measurement from the bottom of the inside channel to the top of the wheel well for a 76 FJ40 (9/75)...I measure 5 and 1/4 but think I am too short...any help is appreciated...
DSC03235.webp
 
Mine is 5 3/4" from the lowest point on the wheelwheel- i.e. not the raised panel. 6/76 FJ40
 
Thanks..where do I get another 1/2 an inch

I was lining up the botton of the CCOT wheel well with the rear bed lip...I can't imagine the sides of the CCOT wheel wells are 1/2 inch longer than rear bed lip upon which they are welded...I am going to call CCOT in the am...pic #1 below is the wheel well side matching up with the rear bed lip..pics #2 and #3 show the lip of which I speak...
DSC03236.webp
DSC03238.webp
DSC03239.webp
 
Back
Top Bottom