Need help with PS leak

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 26, 2005
Threads
11
Messages
83
Location
Sherwood, OR
I will admit that i do not know a lot about the fj80 power steering system

obviously. So here is my problem. I have a 1994 fj80 all stock and it is using

one complete resevor of power steering fluid every 200 miles. I have changed

the high pressure hose and degreased the whole system so its spotless.

i have gone through 3 qts of fluid now and i cannot find where the fluid is

going! No viseable oil anywhere except a wet spot on the other side of the

motor by the ac compressor that looks and should be motor oil.



Where is it possible for the fluid to go? I'm just about ready

to shoot the truck i'm getting so :censor::bang:. Any advice??
 
Last edited:
Lay down under the front end of the truck, just under the radiator. Actually, just in front of the crossmember which is under the radiator. You will see a tube about a foot long that bends back and forth, looking somewhat like a large paper clip. That's your PS cooler.

If you are sure that the PS pump itself and the steering box have no leaks (i.e., no fluid remnants), then I'll bet the cooler has got a leak, and the fluid is running down the cooler to the passenger side where it drips out when under pressure. There are a number of posts on replacing this with aftermarket solutions.

The only other place the fluid would likely be going is if your PS pump is leaking back into the crankcase...have you checked your oil level and found it about 3 quarts high?
 
Lay down under the front end of the truck, just under the radiator. Actually, just in front of the crossmember which is under the radiator. You will see a tube about a foot long that bends back and forth, looking somewhat like a large paper clip. That's your PS cooler.

If you are sure that the PS pump itself and the steering box have no leaks (i.e., no fluid remnants), then I'll bet the cooler has got a leak, and the fluid is running down the cooler to the passenger side where it drips out when under pressure. There are a number of posts on replacing this with aftermarket solutions.

The only other place the fluid would likely be going is if your PS pump is leaking back into the crankcase...have you checked your oil level and found it about 3 quarts high?

So that was a question i was hoping to answer, if the shaft seal is bad, does the oil get mixed into the engine oil? The cooler is fine, that was one of the first things i checked before i replaced the high presure line.

I have checked the enging oil not knowing if the ps fluid could find its way there, the level is fine, but in the past it has used some oil, the truck has about 200k, i thought its a little weird that the enging oil leven hasn't needed to be added too in a while.

So can the shaft seal leak into the crank case???
 
Pretty sure the answer to that is "yes" on a 93-97...

Yes it can. The PS pump rebuild can be kinda a pain - if you can get a new pump for a good price from CDAN, I would do that and keep this one as a spare. I replaced the shaft seal in mine and it just chewed up as soon as I started the truck... not sure why. BUT - it seems to be holding, so I'm not worried about it.
 
Back
Top Bottom