need help accessing front signal lightbulb

[rolx470]

I've figured out how to change the headlight light bulbs, but now the right front signal light bulb is out and I can't figure out how to easily access it. I removed one screw which only loosened the cover, but I couldn't remove it completely.. any help is greatly appreciated.

2000 LX470

 

[1loudLX]

remove that screw on the tab at the top, then pull straight out towards teh front of the vehicle. You might want to pry it between the light housing and the fender...but be careful you dont bend the fender or chip the paint. Best bet is to put a couple fingers on the outer edge and just pull towards teh front of the vehicle straight...should pop right out.

 

[rolx470]

Is there more than 1 screw? It feels like the top on the cover is loose when I remove the screw from the top tab, but the bottom of the cover is still firmly in place.

 

[SINCITY100]

remove that screw on the tab at the top, then pull straight out towards teh front of the vehicle. You might want to pry it between the light housing and the fender...but be careful you dont bend the fender or chip the paint. Best bet is to put a couple fingers on the outer edge and just pull towards teh front of the vehicle straight...should pop right out.

1loudLX is right....

Dont be afraid to give it a good "TUG" to release the lower clip. It feels like there is another screw holding it at the bottom, but there isn`t

Peace!