NATO fuel cans part 2
- Thread starter burnoil
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Thread starter
- #2
Just bought 3 of these and they arrived yesterday. They are used and in very good shape with slight surface rust, but even that was very minimal. Easy to buff out and paint if needed. A few very minor dings, but no biggie. The seals are in awesome shape and seal well. I don't think they will leak a single drop. I also ordered a spout and that was in awesome shape, too. Great deal and no CARB-rated crap!
- Thread starter
- #4
The spout is pretty beefy. I have no doubt it will last a long time. It looks smaller online than what actually ships.
I will post pics tonight after work.
I will post pics tonight after work.
Swiss army spouts are the ultimate NATO can spout. Snap em up guys.
- Thread starter
- #6
What he said!
I was inspecting it closer today at lunch. Quite beefy and very well built.
- Thread starter
- #9
Good question. The cans I got from them had good seals so I didn't look to source any...perhaps I should now just in case.
Deutsche Optik has OEM Jerry Can Gaskets, Set of 4.
Just ordered two cans and spout - items must be back in stock
EDIT: Was notified by email that spouts not in stock and will cost more when they arrive. Then was called and told my CC didn't transmit correctly. Starting to think this site might not be on the level.
EDIT: Was notified by email that spouts not in stock and will cost more when they arrive. Then was called and told my CC didn't transmit correctly. Starting to think this site might not be on the level.
Last edited:
- Thread starter
- #12
Sweet...just ordered some. $10 + $6???? shipping. ugh...oh well.
Have any of you guys tried Scepter's DuraMax Flo n' go fuel container? It holds about 14gallons of fuel. I've seen these in my local auto store
Scepter Consumer - DuraMax
Scepter Consumer - DuraMax
never mind looks like they suck
It seems like any fuel can sold in Calif suck.
Has anyone had any experience with this Products - Tanami Pro
Haven't used it, but it should work ok. Seems almost foolproof. Looks like it lightly pressurises the can which is a decent no mess way of doing it as long as you're using a low pressure compressor.
I still say you can't beat a jiggler siphon because unlike the Tanami pump's 10mm pipe, flexible hose is very difficult to break or permanently kink..