My twilight zone 40

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 23, 2018
Threads
37
Messages
272
Location
Whispering Ranch Az and SoCal
I thought I'd post here as I think the fj25 guys are sick of me whining.
My '67 bone stock FJ40 runs perfect, well almost. When I'm on the road turning right it coughs, shutters and dies. I pull over to the curb, crank on it a bit and it coughs to life. Then runs perfect until the next right. Yep, bizzaro.

The stock rebuilt carburetor has a solenoid in the carb body. I reckon that was meant for emergency issues? I'm thinking of removing the solenoid as that could be the cause of stalling? Is it needed? How do I do it? Not much fun driving with a full tank of fuel to the store and stalling on busy roads like it's empty. And yes, when the ignition is turned on the solenoid clicks.
I'm tired of only turning left. Any and all input is appriciated.
mike
 
Solenoid is a idle solenoid. Shouldn't be causing it to stall. Have you checked the fuel level? Sounds like it may be too high and right turn may be causing it spill over and flood the engine. Post a picture of your of your carburetor so one of the carburetor experts here can verify it is stock. It will also have a date code on it as well.
 
It is officially a '68 built in Sept '67. Has many early parts, one barrel carburetor on a two barrel intake. '68 was an odd year of crossover items. The window of the carb is always 100 percent filled when running. I admit I have zero knowledge when it comes to carburetors and too dumb to learn. But I do weld on live natural gas lines. :cautious:

IMG_5853.webp


IMG_5854.webp


IMG_5855.webp
 
Last edited:
I might know a little about the 68 model? :hmm:

You carburetor has the round sight glass. Will have a line on molded into the middle of that sight glass. Fuel should not above that line. I have a few of those carburetors in another location. Can't remember the date carburetor I currently have on my 9/67 68 model. Had a Carter on it when I bought it back in 1974. After years of running aftermarket carburetors I finally installed a OEM one barrel carburetor.
 
Just went out to double check my statement and yes the window shows 95 percent full, with a 5 percent bubble at the top. The carb was perfect in all instances after the rebuild but slowly started doing the "odd thing" so I do not blame the builder. It still runs perfect going up an incline, straight or left. Juuuuust don't turn right. Hopefully there is an easy way to adjust.
I never do aftermarket if I can possibly find and use factory correct.
 
Could be a dirty needle valve at the float; dirty 'strainer.' Could be a float adjustment. Probably needs an overall cleaning and fuel line inspection.
 
Back
Top Bottom