My brakes finally work

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 11, 2004
Threads
150
Messages
1,043
Location
high desert, ca
NOt like anyone cares, but after maybe 5 months of improperly functioning brakes, they work again. It all started with swapping out front drums for discs. Then, I never got any resistance at the pedal and the rears locked up all the time, could never get the fronts to lock. Put on monte carlo brakes on the back today, easy, around 2-2.5 hrs, and that included fabbing some new hard lines. Now the brakes feel better and the fronts lock before the back. I think all it was was a mismatch in calipers. The rears took so little fluid to actuated and controlled the system somewhat, while the fronts take a huge volume of fluid. I may soon get the 1 1/8" MC, I still think a little more pedal feel would be good. But from all of this, I got new hard lines all around, a new MC, new calipers all around, new rubber hoses, etc.

All in all, I still think properly adjusted drums rock, its just the single circuit MC which is scary when you rip a brake line going downhill with no emergency brake.
 
sounds like you had the same problem I have right now after swapping 60 series knuckles and brakes on my 74. Pedal seems soft and my rears lock up first.
I need a proportioning valve now with the frond discs. One off any disc brake 40 should work. That should fix the mismatch and soft feel.... I hope :D
 
peesalot said:
did you remove the residual valve in the m/c ?
who are you asking?
I definitely did, otherwise the calipers don't release after braking right? :eek:
 
My MC is the 1" v6 4runner. Didn't go after the rear residual valve yet. So far brakes don't seem to be dragging. But I may pull it apart anyways. When I first installed discs in the front, a stock toyota truck proportioning valve wasn't enough restriction in the rear. I kept that and behind it against the frame rails I put in a wilwood proportioning valve. This still wasn't enough with the stock rear brakes. Got one leaky banjo bolt though on the new rear discs. I went with rebuilt, $11.99 calipers, one of them has a s***ty surface under the banjo washer. Does anyone know much about the 1 1/8" MC off the T100's? It seems as if that would be well matched to large calipers all around.
 
Back
Top Bottom