multi-rib belt conversion - not serpentine

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 13, 2003
Threads
109
Messages
2,149
Location
Wichita, KS
I did a few searches and couldn’t find any info on what I’m looking for.

Has anyone converted from the V-belts to the multi-ribbed style (i.e. newer belt design) on their LC or other vehicle? I have been trying to come up with a smaller alternator pulley to bump up the output at all engine speeds however there aren’t any real options out there for the current configuration. After doing some research with my local starter/alternator whiz the size we have now is about as good as it will ever get +/- 1-2 mm OD. If able to locate and convert to the multi-rib type the options for the alternator open up considerably.

Please keep this on topic as I’m not interested in debating the whole multi-belt alternator configuration it has been covered and if we come up with a viable solution that doesn’t cost an arm or leg it just might help others.

Let the brainstorming begin.
 
Why not have the existing alternator pulley machined down slightly? A small decrease in its diameter will lead to an exactly proportional increase in alternator rotations, and it's already small - what 3" in diameter? So machine its circumference 10% smaller and the RPMs go up 10% This way, you could get an alternator pulley from a junkyard (or Cdan) and have it worked on with no vehicle downtime until it's ready to be installed. Another advantage is that you could put the old pulley on if it doesn't work out. And of course you can 'pretest' this by taking readings on your existing alternator at various RPMs to see what RPM increase you want to target and if it's feasible with the amount of metal on the pulley you're comfortable removing while still having enough strength.

DougM
 
The standard pulley has a 72mm OD. It may work but if the existing pulley is turned down to 65mm the belts would need to replaced with much narrower ones of slightly shorter length. IIRC the standard belts are ~10mm wide when new. To get belts to drop farther into the "V" a belt in the order of 6mm would be needed. I'll have to find my spare pulley and measure the "V" and whip up a quick dwg to figure what width belts would be required at a pulley OD of 65mm. I have a feeling even if I was able to locate such a narrow belt the durability would not be sufficient.
 
Back
Top Bottom