More wiring harness issues

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 5, 2006
Threads
127
Messages
745
so about a year ago i had a post about my driving lights not working following the install of the slee wiring harness.

It ended up being an issue with the relays... and slee shipped me two new ones which fixed the issue (headlights wouldnt work, but high beams did)

Now approx a year later... about a month ago i lost one driving light... replaced the bulb...but still no workee. Just tonight i lost the other driving light.. the bulb seems fine. Switching the two relays doesnt fix the problem.. Low beams dont work, high beams work.

Has anyone had this issue...?

Do i need two more new relays..?

I have installed according to directions and used di electric grease.

HELP.. its hard to drive at night with no lights.

Thanks, Colin
 
if the problem is the relays.... how the heck do they work?

i dont have the stock harness anymore... so im kinda screwed.
 
i dont have the stock harness anymore.

How do these relays work? How the heck can i fix them.


I was hoping maybe SLEE can lend some advice.
 
Last edited:
Unplug the upgrade harness and plug the original oe connectors back into the light bulbs. The stock harness is still in the truck. Nothing should have been removed when the upgrade was installed. IE, follow the instructions in reverse.

Check the connectors between the upgrade harness and the factory harness. The relays are only part of the new harness. You still have the factory wiring in the truck.

There is only two things that go wrong, the relays fail, or the connection between the OE harness and the upgrade harness is not good.

Both low beams are switched with one relay and both high beams are switched with one relay. If you loose just one light at a time, then it seems to be a connection issue and not a relay issue. The relay can not just switch one light at a time.
 
I did a test when I did the install of the new harness and to go back to using the OE harness takes literally 5 minutes. IF that. There would have been ZERO good reason to remove the original harness. You probably just have the old connectors pushed in the headlight housing and so you don't see them.
 
i tested the connection between the highbeam jumper to the slee harness and when its unplugged and the regular light connected the light works. when the low beam jumper is dissconected and the light is plugged back into the orig harness... the light still wont work.

sooooo.... somewhere i still have a problem with both low beams...
 
Then I would start checking the bulbs as well as the fuses for the low beam side of the lights. Our harness uses the original power to the bulbs to trigger the relays that supply power from the battery directly to the lights. So if you don't have the trigger signal (ie, stock low beams don't work with stock wiring) then the lights will not work. So it is probably not the harness or the relays. If you have a problem in the original wiring that could also explain the earlier failure of the relays.
 
low beam fuses are in the fuse box next to the battery or under the dash?
 
in the fuse panel next to the battery there is a L and R headlight fuse. both seem fine.

where are the low beam relays located?
 
all fixed up.. thanks for your help slee

:confused:

As an owner of a still-functioning Slee harness, I would like to know what you did to fix this... Just in case.

No offense, Christo. I like the harness.
 
i think i might have had a bad ground.. and crappy bulbs
 
Back
Top Bottom