Mini Swap

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 5, 2003
Threads
319
Messages
2,206
Location
San Antonio TX
I picked up the 84 mini axle this morning, was gonna tear it down in the junk yard but due to the outside temp being what it is in South Texas I decided to just take the whole damned thing. After thinking about it , it is actually to my advantage. It will give me time to take it apart piece by piece, replace old with new and paint everything nice and pretty and reinstall. It did'nt have the tie rods so I will be using the old "starter bushing" trick. One quick question though. While reading thru all of the tech articles It says to take the axle shaft but don't you leave the inner part of the birfield on the old axle, gring it down a little and put the other half of the mini on the other side? Sorry if it's basic stuff, dont wanna screw it up tho.... Also, will the gears from the mini swap to the LC ? is there an advantage to this?

Thanks
Kevin
 
No: Use the Mini birfields (birfields are the outer part of the axles with the bell on them) with your cruiser's inner axles. The inner axles on the short sides may be interchangeable between cruiser and mini, but someone else is going to have to chime in on that.

The grinding is done on the inside lipe of your cruiser's axle housing, not the axle shaft or birfield.
 
On some of the tech articles I've been reading, you disassemble the cruiser axle to this point, See PIC,

do a little grinding inside so allow room for the larger mini knuckle and reassemble. Can someone please verify this.
Thanks
 
Last edited:
While I'm at it, does anyone have a knuckle rebuild kit laying around that they wanna sell?
 
yes, grind the inner axle.housing , make sure you put a rag inside the axel shaft hole, grind some out of the top inner and give it about about 1/8''inch clearance.
 
Back
Top Bottom