Mini PS Conversion on F Engine?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 16, 2006
Threads
66
Messages
185
Location
Altoona, Pa
I have a question about doing the mini ps coversion on a F engine? I searched the forums and the tech links but can't seem to find an answer. Since I only a have single belt pulley at the crank and waterpump, do I need to change both of these to double groove pulleys? It appears Bill Dorry's setup requires double groove pulleys but it appears fairly difficult to change the crank pulley and I'm not sure what would replace it. Any help would be appreciated.
 
Someone makes and sells an add-on crank pulley that bolts to your current single groove. The two groove waterpump pulleys/spacers are to be had also.
Marksoffroad.net maybe?

Not that hard to change out crank pulleys, though. Shelfboy is in Girard, PA. PM him and see what he has. I've bought stuff from him before and it is always good.


Ed
 
I am in the process right now of doing almost the same thing. 71FJ 40 with stock F engine. Already have Scout power steering box. Just picked up a double groove crank pulley (wide inner and narrow outer groove). Just ordered a matching water pump pulley, power steering pump bracket, and right side of 2F engine alternator bracket from Mark at marksoffroad.net .You will need to move your alt from the drivers side to the pass side (2F alt brkt) to allow room for the power steering pump. Mark has a bolt on accessory drive pulley (# 030-05XA) made from billet aluminum if you don't want to change your current crank pulley. However, I do not know if it is the narrow or wide groove item. Mark also has a saginaw type pump bracket that is supposed to be a bolt on to the F engine (# 122-21A). The rest of what I am doing will be different since you are using Mini and I'm using Scout. I already have manual saginaw steering done by the PO so some of my mods needed are already started.

Hope this info helps you.

ps. Last winter I was messing around with the manual sag box and discovered it had a little more than 6 1/2 turns lock to lock, but due to the stops on the axle only 4 1/2 turns were being used. Don't know what rig the box came off of.
 
ps. Last winter I was messing around with the manual sag box and discovered it had a little more than 6 1/2 turns lock to lock, but due to the stops on the axle only 4 1/2 turns were being used. Don't know what rig the box came off of.

Early Camaro
 
you can use one belt if you can set up all the pulleys in a line. That is always an option. I am doing htat right now till I can get some time to run seperate belts via new tensioner for the pump.
 
Back
Top Bottom