Metallic "Clunk" in the T_CASE?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 9, 2005
Threads
27
Messages
93
Location
New York
All of a sudden, no warning, did not build up..................a clunking noise in the t-case of my son's '93. I thought when I first heard it that it was a bad u-joint................NOT! Seems to be right in the t-case and happens when changing from drive to reverse and vise-versa. Vehicle is a daily driver/grocery getter/stock drivetrain and suspension. Not an "off-roader............Any ideas, insight, ideas? Kerry
 
Kerry,

Have you checked the tcase oil level? Maybe a quick fix.....

Also, the driveshafts benefit from regular disassembly, cleaning and regreasing by hand - the zerk fitting on the slip yoke does not allow grease to get all the way up into the splines. Too much grease in there causes expansion and pushes the driveshaft ends towards the tcase and diffs, which is bad for tcase bearings, etc. Seperate the two halves and see how much old grease is in there at the bottom! At 175K, I just performed this service after I noticed the 'clunk' you describe getting worse. I ended up installing new u joints as well. After that, the noise is gone. Dropping the driveshafts will also allow you to assess whether the noise is there without the drivelines connected. Hope this helps!

Brian
 
i had a verry simalar noise in my truck, u joints lookd good at first but i put a pry bar inbetween em and with a little force i could see it move id check them again use a pry bar with a little force on both sides of em to see if they move.......
 
Thanks for the tips and advice.............I'll check both..............or should I say I'll"instruct" my son to check both possibilites out. Kerry
 
Back
Top Bottom