Metal switch under dash?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Truth be told I actually pulled all the mess of wiring out once to try and determine what was making a clicking sound when I put the truck in gear. There was a basketball sized mess of wires stuffed in the kick panel and under the steering wheel. about half of it wasn't connected to anything, so I took it all out. the rest was obviously part of an aftermarket alarm that I seriously considered pulling out and just using the key to get in and out. That same day I pulled out all of the disconnected wires under the steering wheel, the blown factory subwoofer and amp, two different sets of trailer wiring, and two toasted wires running from the battery to the cabin(also not connected to anything). I had a heavy grocery bag full of wires and connectors when I was finished and the clicking was gone(trailer wiring I suspect). The little metal switch was still connected to the mess of wires that is still in the kick panel.

That's awesome.
 
I had a switch like that on my rig, I kept turning it on and off every once in a while....about a month went by, I got a letter from a guy in Australia telling me to cut it out :)
 
Bet is a alarm deactivation switch aka valet switch. The truck probably had an alarm sometime during his life. My truck has one.:steer:
 
my current research indicates the switch simply controls the red light on the dash. Fortunately, nothing tangible changes with it on/off so I am gonna save the energy and devote it to other cruiser tasks :steer:
 
In response to Mark's thread about the differences between an ignition kill and a fuel pump kill- With fuel injection, cutting the fuel pump will not allow the vehicle to even start, and disabling it while running will immediately stop the motor. In other words, you'll know if its a fuel pump kill right away.
 
I have the same switch on my 94 FZJ80. It WAS a kill switch for a remote start. I didn't know I had aremote start until one day when I was working on my BJ60. I was under it when I heard the 80 start up. I got up to see where my wife was going and there wasn't anyone in the vehicle. I walked over and the doors were locked. Some how another person in the neighbourhood started it. I removed the remote starter the next day.

Anyways, if it is what I think, the kill switch is to turn the remote start off when working on the vehicle. Check under the drivers seat for a remote start unit.
 
It is the switch for the alarm system. If the car can't start without the TDS alarm system. Then you move the switch back then insert the ignition key and that's how the car can start. In other words, it disables the alarm so that you can start the car with a valet key. I found out after I lost my keys and only had the valet key.
 
Mine has it as well. For a Viper car alarm/remote start. And mine dissables the remote start.
 
Back
Top Bottom