Manual operation of centre diff

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 4, 2007
Threads
10
Messages
13
Hi all,

I have recently completed a simple (or so I thought) modification that allows a cruiser (in my case a 1996 petrol) to have switcheable centre diff in high and low ratios.

The problem is that after the conversion the f/r diffs do not activiate. In fact there is not power at the switch under any circumstances.

Also, when initially turning n the ignition the warning lights for the diffs momentarily lit. This no longer occurs. When I switch the centre diff switch on its respective light activiates.

For reference the web page I used that shows the modification is...

Slee - Pin 7 Mod for CDL (Toyota 80 Series Land Cruiser)

Any ideas?
 
Just to clarify - you both installed the CDL switch in the dash and pulled the pin 7 wire down below to get full manual control of the center diff, right? And you're trying to engage the F/R lockers with the center already locked?

The only thing I can think of is, could you possibly have broken some other connection when pulling the pin 7 wire? I don't know if power to the other lockers is routed through that same junction box. My mod worked as intended, fortunately.
 
Back
Top Bottom