MAF issues?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 8, 2015
Threads
59
Messages
414
Hi again. I bought last week my first FJ80, it`s a 1992 white one with only 97.000 miles on it, it drives nices, but I think I have some issues with the MAF. I starts the FJ80 every mourning and RPM are at around 1000, then I drive it for around 20 minutes and RPM down to 600-700, last weekend I drove the car around an hour before to stops the car and when I parked RPM were decreasing until the engine turned off, when it was a little cold, I started it again and drove home with no issues. There`s some silicone around the plastic cover of the MAF, I guess previous owner did some "job" to regulate it. Am I right thinking MAF issues? Please let me know, Thanks!
 
Cold starting at 1,000 and then dropping to 650 RPM is normal. The IAC controls the idle speed not the MAF (which really you don't have on your engine). The Air Flow Sensor on the 3FE isn't really a MAF, but if you do work on it, the cable connector is held by a wire bale that you can pry up at each end. Do not remove the two screws on either side!
 
This link may help. It's the two screws that hold the plastic connector to the VAF. On the first photo, they are on the bottom on either side of the black plastic connector. If you remove them and pull, the soldered connection on the board will come apart and you may not be as lucky as pint in that post.
FJ80 3FE Air Flow Meter VAF Stupidity!!
 
Sounds like you've been given the right info here. To add to the conversation, my '93 had an odd idle issue not long after I purchased it. Then I noticed that the plastic cover on the top of the VAF was not completely adhered to the housing. So I cleaned the surfaces, applied tape to make a clean job, and applied some high quality silicone. Problem solved and hasn't occurred again.
 
You may have an air leak. Usually it's the air tube; the accordion part will often crack. I guess you may also be drawing air thru the cover of the VAF like Mighty690 if yours looks like it's been tampered with. Also check for vacuum leaks. If the VAF were completely bad, you's get codes for air flow, intake air temperature,... Hopefully, someone didn't mess with the calibration. You can check and see if the resistance across the terminals of the VAF are correct. You'll need to look in the FSM for the specs.
 
Actually I don`t get any lights on dash, no "check engine" lights, I checked the cover of the VAF and I noticed that silicone is in bad condition with cracks, I`ll check the air tube too. Thanks!
 
FJ80 motor.webp
 
yes, that is correct
 
Yes, and given how the cover looks, there's no doubt that someones been inside. I would definitely check the pin resistance. You could also carefully cut around the silicone and pry the lid off to check the condition of the solder. You should be able to tell if someones tried to repair it. Just be careful because the solder joints are very fragile.

Here is the difference between a MAF and VAF. The MAF uses a heated filament which the intake air flows over. The air cools the filament and the current thru the filament to keep it hot goes up proportionally to the mass flow rate of air, hence MAF. (It would also be proportional to the thermal conductivity of the gas, but we're only concerned with air here.) The VAF uses a vane or flapper inside that gets pushed open relative to the volume flow rate and pressure, hence VAF. With a VAF, ECU also needs the intake air temperature to calculate the mass air flow needed for the fuel injection calculations. The VAF also has a sensor for temperature.
 
Back
Top Bottom