Machining a parking brake drum

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 12, 2004
Threads
28
Messages
161
if your regular drum brake drums get all scored, you can have them machined smooth again, right?

so i would assume the same could be done on the fj40 parking brake drum, right?

where do you get this done at? usually people will say 'any machine shop can do it', but does anyone know of a specific place in the phoenix area?

thanks!
 
Not a machine shop. Any decent mechanic should have the machine lathe to turn the drum, although it can be a little tricky to center drums. After a while, the wall gets too thin and you have to replace, but with parking brake drums it is far more likely you'll have to speedie sleeve other end or just replace the drum because of gear oil leaks before you need to turn it.
 
thanks for the advice. already speedi-sleeved the other end when the case was rebuilt, but the parking brake was ignored for many decades and the inside surface is pretty bad.

so any good mechanic can do the job? ok - thats where i will start. thanks again.
 
It does not need to be shiny, perfectly smooth in order to function properly. Hit it with some 80 or 120 grit sandpaper, and it will be good to go. Have done it for years and it has worked great. You will be surprised how well it works. Further, it will be rusty again after it has sat for a while...perhaps not as quickly as some area, being that you are in AZ. :)



Good luck!


-Steve
 
mattcrandle said:
thanks for the advice. already speedi-sleeved the other end when the case was rebuilt, but the parking brake was ignored for many decades and the inside surface is pretty bad.

so any good mechanic can do the job? ok - thats where i will start. thanks again.

If your drum is REALLY bad you don't want somebody to turn it smooth and nice looking because he could take so much metal out that the adjustment gizmo won't be able to make the brake hold good.
 
If you don't have any luck finding someone to turn that drum, shoot me a pm early next week and I'll turn it for you, our shop is in Tempe.
 
Back
Top Bottom