Here's the M116A2 I picked up a little while ago.
I cut the wheel wells so a 4' x 8' pc. of plywood will fit, installed a new Bulldog hitch with tongue extension, a front wind drop foot jack, a rear bumper with a receiver and shackles, re-fitted the toolbox to the front, new LED stop/tail/reverse light, and re-wired a new 7-wire harness, knowing in the fall I'll probably install a new electric brake axle with Spidertrax and matching Toyota rims........whew
This is my lumberyard run/dump trailer until the the ROAM is gone and a new build begins.....
Pictures are a bit crappy, I took it for a test run annd ran out of daylight.
I cut the wheel wells so a 4' x 8' pc. of plywood will fit, installed a new Bulldog hitch with tongue extension, a front wind drop foot jack, a rear bumper with a receiver and shackles, re-fitted the toolbox to the front, new LED stop/tail/reverse light, and re-wired a new 7-wire harness, knowing in the fall I'll probably install a new electric brake axle with Spidertrax and matching Toyota rims........whew
This is my lumberyard run/dump trailer until the the ROAM is gone and a new build begins.....
Pictures are a bit crappy, I took it for a test run annd ran out of daylight.
