LX 450 not starting

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 20, 2016
Threads
3
Messages
22
Location
North Carolina
I have an 1996 LX450 that won't start intermittently. I turn the key and everything comes on but nothing happens with the starter. I put it in neutral and it does the same thing. I have read the forums and was wondering if this could be the switch or possibly the starter contacts. Any ideas? I can turn the switch back and forth and eventually it will turn over. I'm sure one day it won't.
 
Do you know the last time a starter was replaced?

Do you figure the ignition switch has been twisted so many times failure could be an issue?

Have any experience with a test light / multimeter?

It's either the starter, or the switch of the ignition where you twist the key (pray for the starter, it's cheaper).

Next time it doesn't start, have a metal bar & hammer ready to smack the starter - if it starts after a couple solid but controlled hits, it's the starter.

Flipside if you are good with a multimeter you could check continuity across the start postion & see if it is solid (odds are it is, unless you have say 300K+ city miles/many cranks on it - and even then the ignition switch isn't normally where the problem lies.
 
I do have experience with a multimeter. This problem is intermittent so I was wondering about a false diagnosis. It does have a lot of miles. The LX switch is terribly expensive.

I may just replace the starter or contacts as a precaution.
 
I have a '96 LX450...I've been having this problem for almost 2 years now. Sometimes it's a frequent problem...sometimes it goes away for a month?!?! I recently had my car turn over, but not start. It worked after I inspected the 20 yr. old fusible links...I'm guessing I moved something around and closed the circuit. I ordered a new set of fusible links and I'm hoping the install will fix BOTH problems. Unfortunately, it'll take 2 weeks for an update as I'm out of town for a while.
 
Are your battery terminals clean?
 
My fuel pump relay (FPR) recently failed - intermittently. I first installed a new fusible link, though the original one upon removal looked strong and showed proper continuity. Then I bypassed the FPR and it started right away. I replaced the FPR and now it has started 60+ times in a row over two months, so my conclusion is the FPR was failing but would still work intermittently.
I am not an electronics expert, but it seems to me all relays have moving parts and thus can fail internally (not capable of diagnosing with an external visual inspection). My thought would be to wait until it is not starting and then bypass the FPR and see if it starts. If so, you have the same problem I had.
I believe I bypassed the FPR relay by jumping from the #3 to the #5 connector in the FPR plug, but that's from memory and I'd do a Mud search first to make sure.
Also, Denso makes a FPR relay which is about $35 cheaper than the Toyota one. I bought the Toyota one, not knowing that.
Good luck.
 
Years ago, when I had an intermittent start issue, I was able to diagnose (and temporarily workaround) the problem by knocking on the body of the starter with a hammer (actually - a long pipe and a hammer). This seemed to jar things just enough to get the contacts to engage.

Worn starter contacts are a pretty common issue in these trucks. Pretty easy fix - pulling the starter is the hardest part. Lots of threads here on dealing with that issue. The parts are cheap.

That all said, it could be any number of things, but I'd start with the easy stuff like corroded battery terminals/cables before moving on to the harder stuff.
 
The battery terminals look good but it is a good suggestion to take them off and clean them. That certainly doesn't cost anything. After that I'll look at the starter contacts. It doesn't turn over or even click so I don't think it is the fuel pump as someone suggested. I will know tomorrow
 
So........I pulled off the battery terminals and cleaned them. They weren't too bad. The ground was loose - I could pull it off by hand. Maybe I got lucky.
 
So this morning it did the same thing however I had the door open and could hear the starter contacts pop.

Next step.... change the starter.
 
Back
Top Bottom