Lucas tranny addditive

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

I use synthetic and have never used the Lucas products, but NAPA sells them. I remember them having a demo display sittting out on their counter at their main distribution center. The claim was that it greatly reduced surface tension making a thicker oil perform more like a thinner oil while retaining thick oil protection. The demo appeared to provide strong proof that this was happening.
 
Add some of that Lucas additive to your engine on a cold day, you may think twice about it. I had to squeeze it out, it was not unlike molasses. But on a Land Rover, it worked to help slow (not stop) the leaks. ;)
 
Add some of that Lucas additive to your engine on a cold day, you may think twice about it. I had to squeeze it out, it was not unlike molasses. But on a Land Rover, it worked to help slow (not stop) the leaks. ;)

The engine additive works. My brother had a very noticeable knock in his F motor ('73 fj40) after a hard wheeling outing. 1 bottle of Lucas and the knock all but dissapeared.
 
I'll take sides with agomez on this one. I'd just change the ATF and be done with it. I might consiter putting that stuff in my engine, but when it comes to a tranny with 400 little parts that no one wants to mess with, it'd be kind risky. They probably have tested it successfuly but there are so many channels and pinholes in there in which the fluid flows, and putting thick stuff in there may not be necessary.
 
I wouldn't add anything to a tranny unless you're trying to alleviate a problem and are searching for a solution cheaper than a teardown. The thickeners have as their main intention to make up for the worn tolerances of an aged component that's acting up as a result of the increased tolerances. It's as simple as that.

I'd just change the fluid and drive it unless you're having problems. As others have pointed out, you don't know if there's a part in there somewhere whose rotational speed counts on a certain flow rate of cooling tranny oil. Thicken the oil and slow the fluid flow and what's going to happen? I don't know either but there are a lot of possibilities like that one.

DougM
 
i'd only use an additive if it is leaking or something
 
Back
Top Bottom