lt1 4l60e 3spd placement

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 14, 2005
Threads
120
Messages
248
Hey everyone, I am starting to take my measurements and get a rough idea of how to place my setup. I'll admit its pretty freaking long. The tranny to the end of the t-case is about 36". Even if i place the motor all the way foreward it looks like i am still about 1-2" long....the t-case will hit the factory crossmember. has anyone else had this problem? I could angle the whole setup so i dip under the crossmember but that would give me some terrible ground clearance. Or i could remove the crossmember and build i new one a few inches back..(dont want too) i plan on flipping the rear springs so i could also get 3-4" of distance.
 
Last edited:
Back
Top Bottom