Lost my nuts - o2 sensor

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 23, 2007
Threads
3
Messages
25
Location
Okanagan, BC
For some unknown reason the nuts that hold my front 02 sensor on are no longer there. I hit the gas on the highway yesterday and thought I lost my muffler. Took a look and there was my 02 sensor dangeling below.

Has anyone else had this happen and does anyone know the size off hand? I think they are 1/2 inch or 13mm but wanted to check with the experts.
 
The stock nuts are 12mm and are some sot of locking type similar to the ones that connect the fan to the fan clutch. I am not sure what the pitch is.

I know a mechanic that gave me two nuts that have the same pitch as the 12mm, but in a 13mm. It gave me extra surface area to get the buggers off when they rusted.

Did your studs rust off? My nuts were frozen on there, so there is no way they would have fallen off on their own.
 
Yep, same thing happened to me. I thought I had a exhaust leak for a long time. They finally blew out on me the nuts just disintegrated.
 
Last edited:
i heard a rattling in my exhaust when braked under load, found to be my rear 02 rattling around as the nuts have disintegrated and were no longer there. found some spare M8 1.25 nuts, cleaned off the studs and slapped em back on. its not unusual for the nut to slowly disappear...esp here in rusty raincouver...
 
I'm really not sure what happened to them. They were there (I assume since I never actually checked) and then they were gone. The bolts seem fine just no nuts.

Unfortunately my truck is not rust free. However I have had no problems up until the last month. We had unprecedented snow fall and the roads have been heavily salted. It seems like the new salt has activated the rust and the weak areas have failed.

The gasket between the cats sprang a leak as well as the rear heater lines. I did a temp fix on the heater lines but have not gotten to the gasket yet as i just picked a new one up.

Thanks for the info on the nut size. Once the rain subsides a bit I will be checking everything down under so I don't loose anymore bits and pieces.
 
Back
Top Bottom